The button is usually right next to the area the floppy antenna is connected to the motor head.
Genie garage door opener lights won t turn off.
Step 1 remove the indoor control panel from the wall and use a philips head screwdriver to disconnect and reconnect the wiring.
There is a possibility of a relay stuck on the logic board causing the lights to stay on.
If your genie garage door light will not switch off it could be a problem with the wiring or hardware.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
When your opener lights won t turn off on your genie or another brand of garage door opener call your local garage door company right away.
They will either recommend a part replacement or further troubleshoot the problem.
The only way to fix it is to put a board in it.
It is simple to put a board in.
Press and hold the wall console button until the garage door is completey closed.
Allow roughly 10 minutes to troubleshoot your garage door opener.
If you disconnect the yellow wire from the terminal on the motor unit of the garage door opener and the lights stay on the logic board will have to be replaced.
With sears or liftmaster chamberlain it is near or part of the terminal screw board.
Pull the cover off.
With genie it is most often behind the light lens and flashes red when pressed.
Call the team here at sevan locks and doors right away and they will find the source of the problem.
Check for interference from adjacent photo eye sensors of any brand.
If you do not hear a click coming from the motor housing then the relay on the circuit board is bad.
To small screws at the very bottom of the cover and then one on the left and top right.
Go to the learn button on your garage door opener.
The circuit board on your garage door opener will have to be replaced if you want your light to function properly.
If you are standing behind the opener looking towards the door the board will be on the top left side.