Genie Garage Door Only Opens By Holding Button

Check garage door for binding.

Genie garage door only opens by holding button.

I have a genie intellicode. Door starts down then stops before it is closed. I have 2 craftsman 1 2 hp door openers each car has a remote and i am trying to get my remote to open with the large button on the remote and my wife s door to open with the other button. If this happens to you don t immediately call a professional.

The transmitters remotes will not work to close the garage door. It just opens an inch and stops. If the door. If i lift my finger off the button before that point the door will stop and then i have to press the button again and the door will go back down.

When your garage door won t open all the way it can be quite an inconvenience. A wall console unit for a garage door opener is not a complicated device so it s fairly simple to troubleshoot when something seems to go wrong. Depending on the model most work by connecting two to four wires onto terminals mounting the device on the wall and then plugging the unit into an electrical outlet. First check the batteries within the remote itself to be sure they still carry a charge powerful enough to operate the remote.

You will find that the door will only move an inch or so in the close direction and reverse. I tried resetting them but now the large button opens both doors at the same time. Check for interference from adjacent photo eye sensors of any brand. There are quite a few things that could cause this to happen.

When this happens your garage door will only close by holding down on the wall button or wall console until the door fully closes. Press and hold the wall console button until the garage door is completey closed. Try going inside the garage and holding down the wall switch to override the safety. Not only will this keep you from getting your vehicle in and out of your garage you ll also have a harder time accessing everything you have stored in there.

The garage door opener remote only works up close.