Garage Door Photo Eye Height

The sensors should be symmetrical in this height for the light beams to work properly.

Garage door photo eye height.

Break the safety eye beam. Safety standards regulate this height at 6 inches from the floor surface. To test the safety eye system start the door closing then use a controlled obstruction to. One of the sensors directs a beam toward the other.

Some diy homeowners are not sure as the the correct height of these electronics eyes. If an object interrupts the beam. This is so that any small children or pets will not be hurt if they are in the way of the door. The way they function is quite simple.

The sensors use two photo eye lenses that transmit an infrared beam between them. When the beam is broken the garage door movement should reverse. If the eyes are installed higher a person or pet could get under the beam and not be detected by the photo eyes thus the standard manufacturer s recommendation of 4 to 6 above the floor. Safety sensors include two mounted sections one on each side of the garage door opening.

The photo eyes mentioned above should not be installed higher than six inches above the garage floor. The photo eye sensors on garage doors are located about six inches above the ground one on either side of the garage door. These sensors send out an invisible beam that connects them.